how do you wire this?

[JShadx]

I am not sure which wires go where??

[11secss]

here hope this helps

[novajoe]

I am not sure which wires go where??

Ok gather around kiddies and Uncle Joe will explain this for you.

With all kidding aside this relay can be wired two ways.

I am assuming that this is for your fuel pump so I will explain it that way.


First if you look at the bottom of the relay you will see five pins. Each pin should be labeled A through f.

Here is what each does.

A = NO (normally open) you will want hook your gray wire to this.
C= NC (normally closed) not used
D = Ground
E = Fused source from Bat.
F = positive feed from an ignition source

Hope this helps.